The Mustang's seat you an inch higher and to the back, providing a better comfortable riding position. They are firm but fits your body very easy. The three piece set comes with the rider and passenger saddles and a rider back rest that is a must. It folds to the front for easy access and can be taken out completely. It also tilt and can be adjusted to your riding preference.

I can tell you that they are a must to have compared to the ones that comes from Honda. I ordered the Vintage style since I don't like conchos nor fringes.

 The risers that you see here are not designed for the Valkyrie. They are designed for Harley Davidson bikes but fits very well on the Valk. They are manufactured by Bikers Choice and the description is: Domed Pullback Risers for Sportster, Big Twin #66119. To install them, you will need to use a 1/2" drill bit to open a little bit the OEM bolt holes. No need to re-wire or replace any cable. They will pull back the handlebar like an inch and you may adjust it higher. I love them!

The next two pictures shows the Baker Air Wings. I purchased the clear ones so you may see that they are not noticeable at all. They are used to control the buffeting effect of the bike and you may control them to divert the heat air flow. I personally didn't like the uppers but people says they are a must to control the air to your chest. I balanced out and decided to the look.

The next two pictures are the RIVCO grap rails. These are very easy to install and as you can see, they are hooked to the lower back rest bolt and to the to shock absorber bolt, so you don't need to mess with the hard saddle bags' bolts. I installed both sides and gives the passenger several riding positions while adding comfort and support. Must to have.

The final picture correspond to the Vista Cruise control system. It is not electronic but works pretty fine for me. It actually holds the throttle in the desired position and is very easy to unlock. The installation time is about half an hour but it is not too complicated.

This next picture shows the Pro-One Fork Cap Covers and Fork Stem Nut Cover. They hide the those ugly bolts. They are easy to install with small allen screws.

The last picture shows the Upper Gas Tank Mount Cover. You don't need to continue watching that ugly bolt anymore. It mounts staright forward with a chrome allen screw.